Back to QMetry All Products Help Page
Execution of Parameters and Parameter Values
Before executing parameters along with parameter values in your project, refer below pages to understand:
What is https://qmetrysupport.atlassian.net/wiki/spaces/QTM4JS410/pages/2234067639
https://qmetrysupport.atlassian.net/wiki/spaces/QTM4JS410/pages/2234067664
https://qmetrysupport.atlassian.net/wiki/spaces/QTM4JS410/pages/2234067777
Executing Parameterized Test Cases
Below are the steps to execute parameterized Test Cases:
Once the test case with Parameters is ready, go to Test Cycle and link that test case with a test cycle.
Hover over the test cycle record, the Execute icon becomes visible.
Click on the Execute icon to navigate to the Test Execution Screen to run the test and record the status.
On the Test Execution Screen, you can see the Parameter Groups under Step Details. Each Parameter Group has its test steps under it.
Execute the test steps under individual Parameter Groups on the screen.
Sync Steps
If steps are updated in the test case, then the link to sync steps will be visible on the execution screen. Click on the provided link to get the updated content of the steps.
Back to QMetry All Products Help Page